A black and white photo of a person walking down a street

Ealing homes

Sloping floors in an old house: what causes them

Describe the slope you have noticed and a specialist firm can tell you whether it needs investigation. There is no charge for an initial enquiry, so find out what the dip means before you worry further.

Talk to someone Read about surveys first

Why sloping floors in old houses happen in Ealing

A floor that leans or dips has a reason behind it. The cause might be decades old or happening right now, and a survey is the only way to know which.

Historic sag versus active movement

Many Victorian and Edwardian houses in Ealing were built with timber joists spanning long distances. Over a century of weight, those timbers bend. A ball rolls towards the bay window or the hallway because the wood has taken on a permanent curve. This historic sag stopped moving years ago.

Active movement is different. If the ground beneath the foundations is shrinking or swelling, the floor will keep changing. You might notice doors that used to close freely now dragging on the carpet, or fresh cracks appearing above skirting boards. A level survey floor house measurement records the exact profile and compares it against earlier readings to separate old settlement from new subsidence. That distinction matters because the repair for each is entirely different.

Ealing sits largely on London Clay, which shrinks in dry summers and swells after heavy rain. Houses here move more than those built on gravel. So a slope that seems minor could be the early stage of foundation movement, or it could simply be the shape the floor has held since 1920.

Notched, weakened or rotted joist ends

Uneven floor old property causes often trace back to the joists themselves rather than the ground. Plumbers and electricians working over the decades sometimes cut notches into the top or bottom of a timber to run pipes and cables. Each notch reduces the strength of that joist, and the floor above it dips.

Moisture is another problem. Where a joist end sits inside a damp external wall, water soaks into the timber. Rotten joists ends damp conditions produce soft, dark wood that can no longer carry its load. The floor above feels bouncy underfoot, particularly near the outside walls where the damage concentrates.

If you notice bouncy floorboards ground floor level, press down near the skirting. Excessive give suggests the support at the wall has failed. A structural specialist uses a moisture metre and probes the timber to check for rot without pulling up the whole room. They can then advise whether sistering new timber alongside the old joist will restore stiffness or if the damaged section needs replacing entirely.

Failed sleeper walls under the ground floor

Most older houses in Ealing have a void beneath the ground floor. Short brick piers called sleeper walls support the joists across this gap. They sit on shallow concrete strips or directly on compacted earth.

These piers can fail. Damp air in the subfloor void erodes the mortar over time. A leaking drain washes away the soil beneath them. Tree roots push through the clay and heave the bricks sideways. When a sleeper wall collapses or tilts, the joists it supported lose their mid-span rest point. The result is a floor that sags in the middle of the room or dips towards one wall.

You cannot see a sleeper wall without lifting floorboards, but the signs show above. A pronounced hollow sound when you walk across the centre of a room, or a visible dip where furniture slides, points to missing support below. A surveyor lifts a small number of boards to inspect the void, photographs the condition of the piers and notes any standing water or root intrusion.

Genuine foundation movement beneath the floor

Sometimes the slope has nothing to do with the timber. If the foundations sink, the walls drop and the floors follow. In Ealing, clay shrinkage during prolonged dry spells is the most frequent trigger. Large trees close to the house draw moisture from the soil, accelerating the process.

Foundation movement rarely affects just the floor. Look at the external brickwork. Stepped cracking along mortar joints, gaps opening between a bay window frame and the main wall, or doors that jam at the top corner all suggest the structure is shifting. Inside, cracks often appear diagonally from the corners of windows or where an extension joins the original house.

When genuine subsidence is suspected, monitoring is the first step. A specialist sets crack gauges and takes precise level readings over several months to measure the rate of movement. Only once the pattern is clear do they recommend a repair such as resin injection to stabilise the ground or screw piling to transfer the load to deeper strata.

How a level survey tells the causes apart

Guessing why a floor slopes leads to expensive mistakes. A measured survey replaces assumptions with numbers. A structural specialist places a digital level or laser across the room and maps the floor surface to millimetre accuracy.

The resulting drawing shows whether the slope is uniform, which suggests historic timber creep, or irregular, which points to localised failure like a collapsed sleeper wall or a rotted joist. If the profile matches the pattern of external wall cracks, foundation movement becomes the likely explanation.

The survey does not require the entire floor to come up. Typically, the specialist lifts two or three boards in strategic locations to look into the subfloor void. They check joist bearing, measure moisture content and inspect the sleeper walls. The whole inspection usually takes half a day for a standard terraced or semi-detached house in Ealing. You receive a written report explaining what the measurements mean and what, if anything, needs doing next.

What a sloping floor actually looks like at home

A slope announces itself in small ways before you ever reach for a spirit level. These are the things you might already be noticing around your rooms.

  1. 1

    Objects rolling on the floor

    Marbles, balls or even dust gather consistently in one corner or along the skirting, following the lowest point of the dip.

    A street with houses and a truck parked on the side of the road
  2. 2

    Doors swinging open or shut

    Internal doors drift on their hinges because the frame is no longer plumb. They may also scrape the carpet at one edge.

    A red brick house under construction with concrete beams and a sandy yard
  3. 3

    Furniture rocking slightly

    Tables or bookcases need folded card under one leg to stand steady, and the gap seems wider than normal manufacturing tolerance.

    brown and white concrete building beside road during daytime
  4. 4

    Visible gap at the skirting

    The floor pulls away from the bottom of the skirting board on one side of the room, leaving a tapered shadow line.

    white and brown concrete building during daytime

Questions about sloping floors in Ealing

Straight answers to the things homeowners ask most. For anything else, read the common questions page. More questions answered.

My floorboards slope towards the bay window, should I worry?
A slight fall towards a bay window is common in older houses because the bay has shallower foundations. If the bubble is only marginally off centre and there are no new cracks, it is likely historic. But if the slope has worsened recently, arrange a survey to rule out active movement.
How do I tell old settlement from a floor that is still moving?
Old settlement leaves a fixed slope that has not changed in years. Active movement produces fresh cracks, sticking doors and a slope that increases over months. Monitoring with crack gauges for three to six months gives a definitive answer.
My ground floor feels bouncy underfoot, is that joists or foundations?
Bounce almost always relates to the joists or their supports, not the foundations. Notched, undersized or rotted timbers flex under weight. Failed sleeper walls remove mid-span support. A specialist inspects the subfloor void to confirm the cause.
What is a sleeper wall and how do I know if mine has failed?
A sleeper wall is a short internal brick pier supporting ground-floor joists above the subfloor void. Failure shows as a pronounced dip or bounce in the middle of a room. Lifting a few boards reveals whether the brickwork has crumbled or tilted.
What does a level survey involve and how much of the floor has to come up?
The specialist maps the floor surface with digital levels to millimetre accuracy. Usually only two or three boards are lifted to inspect the void below. The survey takes about half a day for a typical Ealing home and produces a written report.
If it is rotted joists, who do I call first, a builder or a structural specialist?
Call a structural specialist first. They determine the extent of the rot and specify the repair. A general builder can then carry out the timber replacement to that specification. Starting with a builder risks replacing wood without fixing the damp source.
Will the slope need correcting before I can sell the house?
Not necessarily. Buyers in Ealing expect some unevenness in period homes. But mortgage lenders may require a structural report if the slope is severe. Correcting it is only mandatory if active subsidence is proven and left untreated.

Find out what the slope in your home means

Send a brief description of the floor and the area of Ealing you live in. A specialist firm reviews the details and advises whether a survey is needed. There is no fee for this first step and no obligation to proceed.

  • No cost to enquire
  • Local specialists respond
  • No obligation to proceed

The details you send are passed to a single independent subsidence firm, and a fee may come to us from that firm once the enquiry has been handed over. You are charged nothing by us, further quotations remain entirely your own choice, and our privacy notice sets out in more detail where the information you give ends up.

You can also email hello@ealingsubsidence.co.uk